The sewage mixer needs to pay attention to many aspects in the operation process to ensure its normal operation, extend its service life and improve the efficiency of sewage treatment. Here are some key considerations:

First, equipment inspection and maintenance

Check equipment status regularly:

Regularly check the components of the mixer, including the mixing shaft, impeller, gear motor, etc., to ensure that they are tight and not loose.

Check the oil amount and oil temperature to ensure that there is enough lubricating oil in the oil chamber to avoid damage to the equipment due to poor lubrication.

Check whether the cable is damaged or broken, and whether the cable inlet seal is intact to prevent leakage or short circuit.

Rotation direction and insulation check:

Before starting, check whether the rotation direction of the mixer is correct to avoid equipment damage caused by the wrong direction.

Check the insulation performance of the device to ensure good insulation to prevent electric shock accidents.

Replacement of worn parts:

Regularly check the lifting device, swing rod and other easily worn parts, timely replacement of severely worn parts to ensure the normal operation of the equipment.

Second, operation standards and safety

Follow the operating procedures:

During operation, follow the instructions and operating procedures of the equipment to avoid violent vibration or improper operation of the equipment.

Start and stop note:

Before starting the device, ensure that there are no obstacles around the device to avoid collision.

When stopping, the mixing speed should be gradually reduced first, and then the power supply should be cut off to avoid the impact of sudden shutdown on the equipment.

Safety environment inspection:

When the device is running, periodically check the safety environment around the device to ensure that there are no inflammable and explosive materials or other safety risks.

Do not climb or perform other dangerous acts on the equipment to prevent accidents.

Third, performance monitoring and adjustment

Monitor mixing effect:

Regularly check the mixing of sewage in the mixing tank to ensure that the sewage is fully mixed evenly.

Observe the growth of microorganisms, adjust the operating parameters of the mixer according to the actual needs, in order to promote the metabolism of microorganisms and the decomposition of sewage.

Adjust the mixing speed:

According to the amount and nature of sewage treatment, adjust the mixing speed of the mixer in time to achieve the best mixing effect.

Avoid high-speed stirring for a long time to reduce equipment wear and energy consumption.

Fourth, cleaning and maintenance

Regular cleaning of equipment:

Clean the dirt and sediment on the mixer regularly to keep the equipment clean and hygienic.

During the cleaning process, avoid using corrosive cleaning agents to avoid damaging the surface of the equipment.

Lubrication and maintenance:

Regularly lubricate and maintain the lubrication parts of the equipment to ensure the normal operation of the equipment.

Check and replace aging seals and wearing parts to ensure the sealing performance and operating stability of the device.

In summary, the sewage mixer needs to pay attention to equipment inspection and maintenance, operation specifications and safety, performance monitoring and adjustment, cleaning and maintenance and other aspects during operation. By following these precautions, you can ensure the normal operation of the sewage mixer and the efficient treatment of sewage.

Nanjing LanJiang Water Treatment Equipment Co.,Ltd manufactures equipment for wastewater treatment. We were established in 2001. Since then, we designed and produced submersible mixers, top entry mixers, aerators and other wastewater treatment equipment.